Staalindustrie

That’s exactly what the range for the metal industry is built for. Individual components are coated against corrosion and combined with stainless steel; pump housings are weather-resistant and saltwater-resistant versions are available. Explosion-proof and class-certified components are available on request, with ATEX and, where needed, IECEx compliance. For chains in dusty zones, grease injection directly

That varies greatly by manufacturer and configuration. As a guideline: 150 to 600 points per casting strand, 200 to 800 over an entire rolling line, 100 to 400 per conveyor line or furnace zone, 40 to 150 per crane, and 60 to 300 per roller table section. We count them during the installation scan and

Lubricant consumption drops by up to 33% because dosing is exact instead of estimated. The manual lubrication round of 15 to 20 minutes per machine per cycle also disappears. The biggest gain is usually not in the grease itself but in avoided downtime: 40 to 60% of maintenance costs stem from inadequate lubrication, while lubricants

Because the bearing there needs not only lubrication but also cooling. SKF CircOil systems lubricate and cool at the same time and remove dirt, water, and air particles from the oil. SKF explicitly names roll-stand drive gearboxes, converter drives, gears, and backup-roll plain bearings as applications, and positions the system for applications above 80 °C

In two ways, depending on the position. For rolls and roll inserts in the continuous casting plant, and for bearings in rolling mills and straightening machines, oil-air lubrication is the technique of choice: it delivers a continuous, finely dosed oil flow, keeps dirt out, and cools at the same time, without forming an oil mist.

Yes, provided you choose the right system type. Dual-line systems are designed for this: up to 2,000 lubrication points over distances of 120 metres and more, at pressures up to 400 bar, in dirty, wet, or damp environments with high back-pressure at the lubrication point. If one pair of outlets becomes blocked, the remaining points

SKF literally names LGEP 2 among the typical applications for work-roll bearings in the steel industry: a lithium-soap grease with EP additives, good mechanical stability, and very strong corrosion inhibition under harsh conditions and vibration. Where high temperature and significant water ingress occur together, LGHB 2 is the better choice — it retains its load-carrying